Blodgett ZEPHAIRE-G PLUS Spezifikationen PDF herunterladen (Seite 10)

Installation

Ventilation

DIRECT FLUE ARRANGEMENT

When the installation of a mechanically driven exhaust

hood is impractical the oven may be vented by a direct

ue arrangement.

WARNING!!

It is essential that the direct ue be installed

as follows. Incorrect installation will result in

unsatisfactory baking and oven damage.

The ue must be class B or better with a diameter of 6”

(15 cm). The height of the ue should rise 6-8 ft (2-2.5 m)

above the roof of the building or any proximate structure.

Never direct vent the oven into a hood. The ue should be

capped with a UL Listed type vent cap to isolate the unit

from external environmental conditions.

The direct vent cannot replace air consumed and vented

by the oven. Provisions must be made to supply the room

with sufcient make-up air. Total make-up air require-

ments for each oven section should be approximately 30

CFM (.85m3) per section. To increase the supply air en-

tering the room, a ventilation expert should be consulted.

Installing the draft hood

Ovens ordered for direct venting are supplied with a draft

hood. Install the draft hood as follows:

1. Place the draft hood over the ue connector.

2. Secure both ends with the sheet metal screws pro-

vided.

Flue

Draft Hood

Front of Oven

Figure 8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Keine Kommentare

Blodgett ZEPHAIRE-G PLUS Spezifikationen Seite 10